“Chrome Automatic Transmission Handle Shrouds” made to fit 2005-2007 Mustangs. This product uses a stunning and classic multi-groove design or smooth design that matches and enhances the classic beauty of the ‘05 plus Mustangs. Flowing lines work with the standard interior and upgrade packages. Made from quality 6061 T6 Billet Aluminum, this product is precision machined, then polished and quadruple chromed.

There are no higher standards in chroming. Hands on product that is noticed immediately!

Simply set into place and tighten side set screws to hold solid. Installation takes a minute.

Excellent looks, design and finish.

Choose from "Smooth Style" or "Grooved Style" Below!

“Chromed Mustang Rear Anchor Medallions”. Sold as a pair, these are made from quality 6061 T6 Billet Aluminum, precision machined, then decorative polished and triple chromed. Simply a stunning product that is noticed immediately!

Installation is very easy. Clean the intended location area with soap and water to remove any grime that may cause poor bond. Set into place to review location. We highly recommend having a second person to assist in setting up the proper alignment, as getting the product properly turned (obviously not a problem with the smooth style) is pretty tough. The rear area of the car is pretty tight and not easy to move around in. Remove the backer from the 3M tape on the back of the part. Slowly set into place, review location and upon being satisfied with it, press down to adhere. This product can be lifted and moved if not pressed down, but try not to do this more then a few times, as it will reduce long term bond. Part will hold immediately, but will take 24 hours to reach full bond. We use high quality 3M tape that will reach very high final bond strength. Please keep in mind, upon putting into place, you will not be able to use the rear child seat anchor points again without removing this product.

Choose from "GT Style" or "Grooved Style" below! Click on "Larger Image" below the picture of the "Grooved Style" to see the "GT Style".

 “Chromed AC Fill Cap Cover” made to fit 2005-2007 Mustangs and other select Ford vehicles. This product uses stunning and classic multi-groove design that matches and enhances the classic beauty of the ‘05 plus Mustangs. Flowing lines give a spectacular and classy look. Made from quality 6061 T6 Billet Aluminum, this product is precision machined, then polished and triple chromed. There are no higher standards in chroming.

Hands on product that is noticed immediately! Simply dab a bit of silicone adhesive on top of the existing AC fill cap and set into place. Installation takes a minute. Excellent looks, design and finish.

 “Chrome AC Knob Covers” made to fit 2005-07 Mustangs and other select Ford vehicles. 2007 Mustangs had the AC knobs changed in a way that did not allow the removal of them. This eliminated the ability to replace this highly customized car part. These fit 2007 vehicles, but even work with 2005 and 2006’s too (some people don’t want to pull off the originals). This product uses a classic blended edge design that matches and enhances the classic beauty of the ‘05 plus Mustangs. Smooth shine give a spectacular and classy look. Made from quality 6061 T6 Billet Aluminum, this product is precision machined, then polished and triple chromed.

There are no higher standards in chroming. This is a stunning product that is noticed immediately! Installation takes a minute. Each part has special two sided tape on the backside. Simply peel off the 3M tape backer and set into place. Parts slide right over the top of the standard knobs.